How to take care your car`s gear

Have you ever had hard time moving the gear lever to change gear in increasing the speed of your car? Alternatively, the gears have been moved to a high position, but we can not gear the car go fast gear because hard to move your car. It could be a symptom of your car clutch problem in the gear shift and it could be that you are able to influence and even cause damage to your car engine.

Coupling system to continue functioning and deciding round of the crankshaft to the transmission (gear) when it starts or when the engine or the engine will stop moving (moving to the drive system). The system is located between the engine and drive system (transmission). Constraints that often happens is the clutch slip, give way, or a sticky clutch.

The main cause of clutch problems in general are worn. Motorists often complain of frequent replace the clutch plates as it is. However, most of which occurred was not due to age factor of the material pembaut gear, but by way of transmission use. There are some riders who do not care about the exact positions of the clutch replacement car while providing lubrication for the clutch.

Do not hang the clutch pedal too long, this practice is often done when traffic jams on the streets or climbing uphill. Stamping that this responsibility can lead to high friction on the canvas clutch that can accelerate engine wear. It does not hurt, but otherwise you do not get used. Do the stamping on the responsibility at the time that really necessary in your driving.

Then adjust the transmission speed of the car with the car to lighten the work of the car. You can set the exact time for the clutch to shift gears by looking at the size of rounds per minute or rpm meter in addition to the speed marker. Of it all, it is not uncommon that the driver drove at high speed, but the position was in second or third gear, or vice versa.

Adjust the height of the clutch properly. there are still free to try to distance, the distance when the pedal was stepped up to something. When the position of the stamping is still 50 percent, but the car's speed was increased, then the settings were appropriate position. Get used to change gear smoothly. Put deeply your feet then remove gently and slowly. Change gear quickly and rough will cause friction clutch hard on the canvas that makes it wear faster. When this occurs, most likely slip also occurred.

You should check and care clutch regularly. So that the coupling conditions can be monitored, you get used to always use first gear to start running, including while stopped on the road even if only briefly. Start with the teeth on it will only accelerate the wear and tear.